There must be a simple solution

From: Mick (mikca_at_bigpond.com)
Date: 10/30/03 

Date: Thu, 30 Oct 2003 02:11:56 GMT

RH9 vanilla

I have a controller attached to a serial port.
I would like to read from and write to this controller

How can I attach a terminal session to this controller?

Entire conversation is in ASCII.

Mick

Relevant Pages

  • Re: Sun StorEdge 3310 array
    ... Current data needs ... > controller. ... Given that I need RAID and I plan to attach it to only one host, ... This is going to be used only for Oracle 9iR2 database files. ...
    (comp.sys.sun.admin)
  • Re: Sun StorEdge 3310 array
    ... Current data needs ... > controller. ... Given that I need RAID and I plan to attach it to only one host, ... This is going to be used only for Oracle 9iR2 database files. ...
    (comp.sys.sun.hardware)
  • Re: Am I using atacontrol attach properly? (sata hotplug issue).
    ... attached to a Sil 3114 controller and 1 attach to an ICH8m. ... I can set ACHI mode for ICH8m in the BIOS. ... the 5th connector shows up as master on ata8. ...
    (freebsd-current)
  • Re: SIL3112 and Maxtor 6Y160M0 SATA Disk: DMA Failure
    ... >> Unfortunately when I do attach my Maxtor SATA disk to this controller ... > experiment with all PCI and memory options in your BIOS, ...
    (freebsd-current)
  • Re: SIL3112 and Maxtor 6Y160M0 SATA Disk: DMA Failure
    ... >> Unfortunately when I do attach my Maxtor SATA disk to this controller ... > experiment with all PCI and memory options in your BIOS, ...
    (freebsd-current)