Re: There must be a simple solution

From: Nils O. Selåsdal (noselasd_at_frisurf.no)
Date: 10/30/03 

Date: Thu, 30 Oct 2003 07:59:41 GMT

In article <3fa0736b@news.comindico.com.au>, Mick wrote:
> RH9 vanilla
>
> I have a controller attached to a serial port.
> I would like to read from and write to this controller
>
> How can I attach a terminal session to this controller?
Try using minicom

Or even getty should do, read its manpage.

Relevant Pages

  • SUMMARY - rsm6.22.1 unable to see A3500FC - any suggestions?]
    ... you can see a disk LUN with probe scsi, then go for the fibre and it ... The real solution is to use the serial port, but this is only for Sun ... or the 6285-3621 controller. ...
    (SunManagers)
  • Re: Restoring a NorthStar Horizon, problems with SRAM board
    ... The Horizon contains a NorthStar ZPB-A3 CPU board, ... Static RAM board, a NorthStar MDS-AD3 floppy controller, a Hayes ... serial port, the left serial port is disabled, the parallel output ... The ZPB-A3 CPU board contains the 2708 PROM boot option which makes ...
    (comp.sys.northstar)
  • SUMMARY: A1000 not responding
    ... Anyway I connected to the A1000 via serial port. ... > something I can do without calling SUN? ... to it and you should begin seeing messages from the controller ... Make sure you have the latest version of the firmware that you were ...
    (SunManagers)
  • Re: A2 5.25" drive on a PC?
    ... > connector hooked into the PC's power supply? ... But when I gave a quick glance for the disk controller manual, ... over the lines than with the serial port where it's all pretty fixed. ... There may have been a good reason to shift some of the work to the controller ...
    (comp.sys.apple2)
  • Re: TimeOut Serial Port
    ... > I'm excanging data with an microcontroller (Atmel) via the serial port. ... > If I disconnect my controller, then the programm hangs up in the following ...
    (comp.lang.cpp)