RH9 Install and some periph's not workin'
From: GregM (gmccormickis_at_sympatico.ca)
Date: 11/24/03
- Next message: Vic: "Re: Best way to remove junk and ads"
- Previous message: osmoma: "Best way to remove junk and ads"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Mon, 24 Nov 2003 09:43:23 -0500
I installed RH9 a couple o' days ago and for th most part I'm likin' it
allot. I was a little bummed out about the lack of NTFS support, but that
was easily fixed up thanks to some good advice from a couple of the guys
here in the group... Thanks again guys.
Now I have a couple of other questions... I have an AHA2940U2W (PCI) SCSI
adapter with 2 10G Cheetah HD's, all that works fine, that's where RH is
residing right now. However, I aslo have an AVA1505/1515(ISA) adapter with
a Relisys VM4542 scanner on it... This one didn't get noticed by the
install software. Older installations used to spot my 2940, set it up as
an AIC7xxx and then ask me if I had another SCSI adapter and I could pick
it out from a list and be on my way again (maybe that was MDK, I'm not
sure anymore). Anyway, I've been through all the config software that the
GUI has to offer and don't see a way to load additional drivers... Any
suggestions would be greatly appreciated.
I also have have a Zip 100p (Parallel) that seems to have gone unnoticed.
THX... Greg.
- Next message: Vic: "Re: Best way to remove junk and ads"
- Previous message: osmoma: "Best way to remove junk and ads"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
