Softwasre RAID1

From: tony (none_at_none.com)
Date: 04/29/05

  • Next message: Kasper Dupont: "Re: Softwasre RAID1" 
    Date: Thu, 28 Apr 2005 22:22:42 -0700

    I believe my drive 0 on my 2 drive SCSI raid system is failing. HOw do I go
    about
    replacing the disk 0.

    This is not a hot swappable system. Just 2 drives on a SCSI bus to a 39160
    card

    Should I just

    powerdown the system

    take hard drive 0 out

    put in the new hard drive

    and bootup the system.

    IS this all i need to do?

    will the raid recreate itself on bootup?

    thanks

  • Next message: Kasper Dupont: "Re: Softwasre RAID1"

    Relevant Pages

    • Re: Re: Where Did It Go?
      ... says about the drive on bootup. ... not handling removable IDE drives, or that it does not assign a ... It is possible that when you put a disk in the drive, ... I did have a disk in the drive, but it was a fat16 formatted disk. ...
      (Fedora)
    • Softwasre RAID1
      ... I believe my drive 0 on my 2 drive SCSI raid system is failing. ... replacing the disk 0. ... Just 2 drives on a SCSI bus to a 39160 ... and bootup the system. ...
      (comp.os.linux.hardware)
    • Re: Best hard drive repair software?...
      ... I have two external Maxtor one touch drives and they ... the errors were listed at bootup (before XP ... >diagnostics on the drives and map out bad sectors so they are not used. ... Your disk is dying. ...
      (microsoft.public.windowsxp.general)
    • Re: 3B2 Disks
      ... being able to read the disk in its present format. ... 2 MFM drives on a custom controller. ... SCSI came much later as an add on card. ...
      (comp.sys.3b1)
    • Re: OT-True Image Backup
      ... Make sure the USB drives file system is NTFS and not FAT32.. ... Jaymon is correct in that the disk image you create and save to the D: ... partition of your USB external HDD will have no effect on the other ... Step-by-Step Instructions for Using the Acronis True Image Program to Backup ...
      (microsoft.public.windowsxp.help_and_support)