PATA Problems
- From: rsriprac@xxxxxxxxx
- Date: 10 Dec 2006 15:41:10 -0800
Hello,
I have been having a problem with getting access to a drive I
installed. My motherboard is a Asus PC-DL Deluxe and it comes with an
onboard Promise 378 RAID controller. I am not setting it to any RAID
but just using it to connect to additional hard drive.
The drive shows up fine under sda. I was able to partition it with
fdisk:
Disk /dev/sda: 163.9 GB, 163928604672 bytes
255 heads, 63 sectors/track, 19929 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/sda1 1 19929 160079692 83 Linux
And I was successful in mounting it to /mnt/sda1. So I edited the
/etc/fstab file and added:
/dev/sda1 /mnt/sda1 ext3 defaults
0 0
After I rebooted the drive does not mount and I can not mount it
manually:
$ sudo mount -v /dev/sda1 /mnt/sda1/ -t ext3
mount: /dev/sda1 is not a valid block device
Here is my dmsg:
SCSI subsystem initialized
libata version 2.00 loaded.
sata_promise 0000:03:04.0: version 1.04
ACPI: PCI Interrupt 0000:03:04.0[A] -> GSI 23 (level, low) -> IRQ 193
sata_promise PATA port found
ata1: SATA max UDMA/133 cmd 0xF0836200 ctl 0xF0836238 bmdma 0x0 irq 193
ata2: SATA max UDMA/133 cmd 0xF0836280 ctl 0xF08362B8 bmdma 0x0 irq 193
ata3: PATA max UDMA/133 cmd 0xF0836300 ctl 0xF0836338 bmdma 0x0 irq 193
scsi0 : sata_promise
ata1: SATA link down (SStatus 0 SControl 0)
scsi1 : sata_promise
ata2: SATA link down (SStatus 0 SControl 300)
scsi2 : sata_promise
ata3.00: ATA-7, max UDMA/133, 320173056 sectors: LBA48
ata3.00: ata3: dev 0 multi count 0
ata3.00: configured for UDMA/133
Vendor: ATA Model: Maxtor 4R160L4 Rev: RAMB
Type: Direct-Access ANSI SCSI revision: 05
SCSI device sda: 320173056 512-byte hdwr sectors (163929 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
SCSI device sda: 320173056 512-byte hdwr sectors (163929 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
sda: sda1
sd 2:0:0:0: Attached scsi disk sda
device-mapper: ioctl: 4.7.0-ioctl (2006-06-24) initialised:
dm-devel@xxxxxxxxxx
device-mapper: multipath: version 1.0.4 loaded
device-mapper: multipath round-robin: version 1.0.0 loaded
device-mapper: table: 253:0: multipath: error getting device
device-mapper: ioctl: error adding target to table
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
audit(1165767520.088:2): enforcing=1 old_enforcing=0 auid=4294967295
security: 3 users, 6 roles, 1560 types, 166 bools, 1 sens, 1024 cats
security: 58 classes, 48173 rules
sd 2:0:0:0: Attached scsi disk sda
device-mapper: ioctl: 4.7.0-ioctl (2006-06-24) initialised:
dm-devel@xxxxxxxxxx
device-mapper: multipath: version 1.0.4 loaded
device-mapper: multipath round-robin: version 1.0.0 loaded
device-mapper: table: 253:0: multipath: error getting device
device-mapper: ioctl: error adding target to table
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
audit(1165767520.088:2): enforcing=1 old_enforcing=0 auid=4294967295
security: 3 users, 6 roles, 1560 types, 166 bools, 1 sens, 1024 cats
security: 58 classes, 48173 rules
SELinux: Completing initialization.
SELinux: Setting up existing superblocks.
SELinux: initialized (dev dm-0, type ext3), uses xattr
SELinux: initialized (dev usbfs, type usbfs), uses genfs_contexts
SELinux: initialized (dev tmpfs, type tmpfs), uses transition SIDs
SELinux: initialized (dev debugfs, type debugfs), uses genfs_contexts
SELinux: initialized (dev selinuxfs, type selinuxfs), uses
genfs_contexts
SELinux: initialized (dev mqueue, type mqueue), uses transition SIDs
SELinux: initialized (dev hugetlbfs, type hugetlbfs), uses
genfs_contexts
SELinux: initialized (dev devpts, type devpts), uses transition SIDs
SELinux: initialized (dev eventpollfs, type eventpollfs), uses task
SIDs
SELinux: initialized (dev inotifyfs, type inotifyfs), uses
genfs_contexts
SELinux: initialized (dev tmpfs, type tmpfs), uses transition SIDs
SELinux: initialized (dev futexfs, type futexfs), uses genfs_contexts
SELinux: initialized (dev pipefs, type pipefs), uses task SIDs
SELinux: initialized (dev sockfs, type sockfs), uses task SIDs
SELinux: initialized (dev cpuset, type cpuset), not configured for
labeling
SELinux: initialized (dev proc, type proc), uses genfs_contexts
SELinux: initialized (dev bdev, type bdev), uses genfs_contexts
SELinux: initialized (dev rootfs, type rootfs), uses genfs_contexts
SELinux: initialized (dev sysfs, type sysfs), uses genfs_contexts
audit(1165767520.444:3): policy loaded auid=4294967295
.
- Follow-Ups:
- Re: PATA Problems
- From: noi
- Re: PATA Problems
- Prev by Date: Stats linux.redhat (last 7 days)
- Next by Date: yum errors after yum-plugin-kmdl update
- Previous by thread: NEED HELP
- Next by thread: Re: PATA Problems
- Index(es):
Relevant Pages
|
|
