Re: Trouble installing Oracle 10g on RHEL 4

Jack wrote:
I been trying to install Oracle 10g on Red Hat Linux. The message I
get is:

<snip>

It does not matter what I use for the window server. I 'xhost +' from
the full domain name, short name, IP address, loop back, etc. I get
the same message ...Can't connect ... No protocol specified ... The
Linux machine using a gnome window to access everything and I suspect
that may be the core of the problem, but I do not know for sure.

Any help or pointers will be appreciated.


Hey,

Here are a couple of links for things to double check:

http://tinyurl.com/2mkcu2
http://www.orafaq.com/forum/t/74948/0/

From looking over these, it would seem that your 'xhost +' was not done
as the proper user... if your issue is the same.

S.



--

Bill will have to take Linux from my cold, dead flippers.

-Tux.
.

Relevant Pages

  • Re: Read system call is reading what is being writtein instead of OK when communicating with modem
    ... altogether and shifted development to a linux machine. ...
    (comp.os.linux.embedded)
  • Re: Raw Disk I/O under Linux
    ... >>take the address of that space, add 4095, and then mask with ... you could use memalign() or posix_memalign(the latter is ... Linux machine, but it is mentioned in. ...
    (comp.os.linux.development.system)
  • Re: libxml and DJGPP
    ... Timo Schlüßler wrote: ... snip ... ... I didn't use unzip32.exe but the unzip from my linux machine, ...
    (comp.os.msdos.djgpp)
  • Re: Port 7 problem
    ... Kamil Muzylo wrote: ... > I tried this code on a linux machine with the newest Java installed. ... That's because Linux, by default, doesn't have the echo service ...
    (comp.lang.java.programmer)
  • Re: float algorithm is slow
    ... the above loop take 2 seconds in c or c++ ... > on Linux machine. ... just a hint (mathematics is fun): ... can be calculated using one single multiplication and one single ...
    (comp.lang.c)