PCI bios bug Not using MMConfig

I installed FC6 on a brand new system after my failed attempts to
install FC3 and recompiling the kernel 2.6.20 both of which did not
worked (infact the problem was that my system was extremely slow it is
Pentium D) then at the first boot when I did not even had a user
account
I got following errors:
PCI BIOS Bug area at e0000000 is not E820 reserved
PCI Not using MMConfig I am really curious to know what these errors
mean.

What I did to get rid of these erros was I went to my BIOS and enabled
the Single Processor Option after which the system was working
normally but I had a same problem when I tried to use FC3 with kernel
2.6.20 it
gave me a BIOS Bug error with some no. tell me what files I should
look to find the exact cause of error.

.

Relevant Pages

  • why my FC6 start so slowly?
    ... I installed FC6 on my IBM R51E laptop. ... the new kernel starts quite slowly, when setting host name and starting HAL, but the old one goes fast. ...
    (Fedora)
  • Installation of FC3 fails on Promise SATA378 controller
    ... I have been trying to install FC3 and FC2 on a new laptop that has Promise ... not RAID (I have tried RAID mode with no success). ... only for 2.4 kernel. ... to where i can find drivers for 2.6 kernel? ...
    (Fedora)
  • Xen guest question
    ... I'm planning on venturing into the world of Xen if I ever finish downloading FC6, ... Is the guest OS kernel different than the "native" kernel? ... Or is hypervisor support just built in and the kernel figures out when it happens ... Or to ask the question another way: If I installed FC6 on a separate partition to dual ...
    (Fedora)