how to access other hard drive data
My dell server has 5 drives
drives 0-2 is in a raid 5 and has old data on it
drives 3-4 is in raid 1 which i installed rhel5 on
originally i could not boot into the raid 5 due to a bootloader or kernel
panic error on boot after a redhat 9 to rhel5 direct upgrade.
So I added the two drives and created a mirror and install rhel5 on fresh.
its boots fine but now i want to access the raid 5 data
how do i do that?
- Re: Problems with software RAID on SATA
... Connected to this are two 320GB drives ... >>which I want to turn into a RAID1 array. ... >>I'm almost certain it's a problem with initting the RAID arrays at boot. ...
- Re: Paul and Old Man: Cannot fix RAID5 failure ...
... I removed the drive reported in error, no boot or rebuild. ... I tried Universal Boot Disc but it won't load the RAID driver ... I was considering a parallel WinXP installation on a 4th disk, ... Maybe like in my case, actually 2 drives failed, while the RAID bios ROM ...
- Re: [SLE] please!! help me, completly lost!
... >machine which was equipped with hard drives configured as RAID.. ... or else to boot from a floppy. ... This is due to a bug in grub. ... Once booted you can switch to grub and setup the MBR on both drives. ...
- Re: M2N-SLI Deluxe Raid setup questions
... I had assumed that since Windows recognized my array at one time that it should work. ... For #4, After I built the RAID array, I had to unplug the IDE drive (the original boot drive) for the RAID array to boot. ... Then I added two WD 250 GB SATA drives and after a little futzing around I got them configured. ...
- Re: Hardware recommendation for collocation
... manage the RAID and run a cronjob to tell me if anything has gone ... alternate boot media, picking which kernel to boot, and toggling the ... Do they work well with Debian, ... SCSI hot-swap drives, with the NetRaid card, e100 ethernet. ...