Re: dell 2950 w/ perc 6/i controller will not pxeboot

I think you would have to reset the controller, try resetting the
controller from BIOS and see if it works.

Relevant Pages

  • Re: NForce2 pseudoscience stability testing (2.6.0-test11)
    ... doesnÿt the kernel get to ... Bios revision? ... 00:00.0 Host bridge: nVidia Corporation nForce2 AGP ... 00:02.0 USB Controller: nVidia Corporation nForce2 USB Controller (rev ...
  • Re: SIL 3112a Controller Issues....
    ... I'm still kind of thinking that the Intel controller _should_ be OK given my ... There are known issues with the earlier nvidea chip that uses Active ... The mainboard BIOS is the latest and the SIL BIOS (that's integrated into ... A SIL3112 on a motherboard, is handled a bit differently than a SIL3112 ...
  • [PATCH 2.4] decrypt/update ide help entries
    ... This add-on card is a bootable PCI UDMA controller. ... happen if the BIOS revisions of all installed cards do ... Promise FastTrak LP/TX2/TX4 ...
  • RE: Can FreeBSD safely use a (un-booted from) drive that is invisible to the BIOS?
    ... ata controler but have HD on wrong ribbon nipple to match master ... ad0 is the boot drive. ... It is recognized by the BIOS, obviously, ... ad2 is the only device on the second controller and it is definitely ...
  • Re: Loss of SCSI boot after CMOS battery replacement
    ... result of my old motherboard BIOS after all. ... controller takes priority over the SCSI ... IDE first to SCSI first. ... SCSI drives and Win98. ...